Interruttore freno stazionamento
Handbrake switch
1. Take out the handbrake connector and perform
continuity checks between the terminal and the
body ground.
2. Make sure there is continuity between terminals
when the handbrake lever is pulled.
3. Make sure there is no continuity between termi-
nals when the handbrake lever is released.
Lunotto termico
Heated rear window switch
1. Remove the heated rear window.
2 Make sure there is continuity between the respective terminals as indicated in the table below.
KEY:
1= To the defroster
2= Ground
3= Switch
C= Bulb
Continuity table
A= Switch
B= Terminal
Interruttore regolazione proiettori
Headlamp light beam adjustment switch
1. Remove the switch for headlamp light beam adjustment.
2. Check continuity between the terminals, as indicated in the following table.
PORTER 1.3 16V Electrical system
ES - 89