PIAGGIO PORTER 1.3 16V 2008 User Manual

6. Fit the oil filter on the cylinder block interposing
a new gasket.
Locking torques (N*m)
Oil filter - Cylinder block 15÷22
7. Fix the gaskets of the oil sump to the cylinder
block.
N.B.
- THE OIL SUMP GASKETS ARE LOCATED IN TWO
POINTS: ONE ON THE OIL PUMP SIDE AND THE OTHER
ON THE FLYWHEEL SIDE. FIT THE GASKET PROTRUDING
PART IN THE SPECIFIC SECTION OF THE CYLINDER
BLOCK.
8. Apply the sealant onto the fixing section of the
oil sump cylinder block as shown in the figure on
the right.
N.B.
- MAKE SURE THAT THE SEALANT IS APPLIED TO BOTH
OIL SUMP GASKET ENDS, SO THAT THE PARTS ON
WHICH IT IS APPLIED CAN OVERLAP.
9. Fit the oil sump on the cylinder block with bolts
and fixing nuts.
10. Tighten in the same way, the bolts and nuts
fixing the oil sump to the prescribed torque in two
or three stages.
Locking torques (N*m)
Oil sump - Cylinder block 7÷12
Engine PORTER 1.3 16V
EN - 356

PIAGGIO PORTER 1.3 16V 2008 Specifications

General

Brand	PIAGGIO
Model	PORTER 1.3 16V 2008
Category	Automobile
Language	English