PIAGGIO PORTER 1.3 16V 2008 User Manual

•
By opening one door of the vehicle, the siren is activated for all the time during which the
door is open, while by opening and closing the door again the siren is activated for a period
of about 2".
•
In both cases, once the siren sound alarm has finished , there is a turn indicator flashing
and a sound signal.
•
By activating any other device, at each alarm reception, or in case of signals coming from
electrical connections (e.g. bonnet switch) there is a turn indicator flashing and a sound
signal.
•
Release the status LED switch or remove the short-circuit carried out previously.
The alarm indicates the end of the diagnosis procedure with a sound alarm and a turn indicator flashing.
Control for self-powered siren/pager
The alarm control unit has the command to use an additional siren with the Yellow-Black wire (there is
no negative lead during the alarm activation). In case it is desired to reverse the command (there is a
negative lead during the alarm activation) follow the operations described below:
•
With the alarm not powered, turn the starter key to "ON".
•
Power the control unit.
•
Take the starter key back to "OFF".
TO REVERSE THE COMMAND AGAIN, IT IS NECESSARY TO REPEAT THE OPERATIONS PRE-
VIOUSLY DESCRIBED. CHECK THERE IS A NEGATIVE LEAD DURING THE ALARM ACTIVATION
TO CONNECT THE PAGER.
Programmable functions
1. Sound alarms
This function allows the user to exclude all the sound alarms permanently. For programming see the
relevant paragraph.
2. Panic alarm or car-finder
The PANIC ALARM function allows the user to activate the visual signalling/sound alarms intentionally,
simply by pressing key No. 2 of the radio control independently of the alarm status.
The alarm warning lasts for about 30", and it is possible to stop such warning by pressing key No. 2 of
the radio control again.
During the alarm warning, the status LED remains steadily on.
If during the programming phase the PANIC function is disabled, the "CAR FINDER" is activated.
This function allows, only with the ALARM ACTIVATED, to obtain a short visual signalling/sound alarm
by pressing key No. 2 of the radio control. Such function is useful in case it is necessary to trace the
vehicle inside a car park, without causing useless alarm conditions.
The visual signalling/sound alarm comprises a siren grave tonality and simultaneous turn indicator
flashing.
SOUND ALARM EMISSION IS SUBJECT TO THE ENABLING OF ALARMS DURING THE PRO-
GRAMMING PHASE OF ACCESSORY FUNCTIONS.
3. Current absorption sensor
Electrical system PORTER 1.3 16V
ES - 140

PIAGGIO PORTER 1.3 16V 2008 Specifications

General

Brand	PIAGGIO
Model	PORTER 1.3 16V 2008
Category	Automobile
Language	English