In case of waterproof connectors, probes A must
be inserted in the connector on each cable har-
ness side.
- If the waterproof connector is checked without
removing waterproof rubber, be careful not to de-
form the connector terminal during the probe ap-
plication.
Visual inspection and contact pressure check
1. Disconnect the connectors on both sides of the
relevant cable harness.
2. Visually inspect for rust on the connector termi-
nal. Besides, check that there are no foreign bod-
ies.
3. Check that the tightened section A is not loos-
ened or damaged. Besides, check that the termi-
nal is not disconnected slightly pulling the connec-
tor wire.
4. Prepare this male terminal of the connector ter-
minal. Insert it in the female terminal and slightly
pull to check the socket. If the socket force is lower
with respect to that one of the other terminals, the
contact could result bad.
- IF THERE IS RUST ON THE TERMINAL OR FOREIGN
BODIES ARE FILTERED, OR IF THE CONTACT PRESSURE
BETWEEN THE MALE AND FEMALE TERMINAL DECREA-
SES, DISCONNECT AND CONNECT THE CONNECTOR
AGAIN SO THAT A MALFUNCTION IS NOT DETECTED. IF
CABLE HARNESS AND CONNECTOR CHECK DOES NOT
SHOW FAILURES, THE MALFUNCTION CODE IS CON-
FIRMED. NOW, IF NO MALFUNCTION PHENOMENON IS
REPRODUCED, IT IS PROBABLE THAT DEFECT WAS
Iniection System PORTER 1.3 16V
IS - 412
To Next Page
Loading...
Need help?
General
