PIAGGIO PORTER 1.3 16V 2008 User Manual

•
Press both keys of the radio control at the same time. The status LED turns off.
•
Turn the ignition key to "OFF".
•
The LED remains on for about 4 seconds to start the first series of flashes afterwards.
•
Once the LED has flashed for five times (corresponding to No. 5, first PIN-CODE digit), press
the status LED switch or turn the ignition key to "ON" for at least one second.
•
Take the vehicle ignition key back to "OFF".
•
The LED remains off for about 4 seconds to start a new series of flashes afterwards.
•
Once the LED has flashed four times (corresponding to No. 4, second PIN-CODE digit),
press the status LED switch or turn the ignition key to "ON" for at least one second.
•
Take the vehicle ignition key back to "OFF".
•
The LED remains off for about 4 seconds to start a new series of flashes afterwards.
•
Once the LED has flashed for six times (corresponding to No. 6, third PIN-CODE digit), press
the status LED switch or turn the ignition key to "ON" for at least one second.
•
Take the vehicle ignition key back to "OFF".
•
The LED remains off for about 4 seconds to start a new series of flashes afterwards.
•
Once the LED has flashed seven times (corresponding to No. 7, fourth and last PIN-CODE
digit), press the status LED switch or turn the ignition key to "ON" for at least one second.
•
Take the vehicle ignition key back to "OFF".
•
Two sound alarms with grave tonality and one with high-pitch tonality signal that the proce-
dure has finished.
CAUTION
DURING THE PIN-CODE PROGRAMMING PHASE, IF THE NUMBER OF FLASHES EXCEED 9,
THAT PHASE IS CANCELLED AND THE ALARM STOPS THE PROCEDURE.
EMERGENCY UNLOCKING THROUGH PIN-CODE
The alarm emergency unlocking procedure through the PIN-CODE is described below. The original
PIN-CODE is set by Gemini, and consists of four digits 1-1-1-1. In the example shown, the alarm is
unlocked with the same digits shown in the CODE-PIN programming example ( 5-4-6-7).
•
To trigger an alarm status.
•
Let the alarm sound for a standard period (about 30 seconds) and wait for the "neutral period
between the two alarm warnings".
During this period the LED remains on for about 5 seconds; turn the vehicle ignition key to "ON".
DO NOT LET THE IGNITION KEY REMAIN IN "ON" FOR MORE THAN 3" OR THE SITUATION IS
INTERPRETED BY THE ALARM AS A THEFT ATTEMPT.
The LED turns off indicating that the "emergency unlocking procedure" has started.
•
Turn the vehicle ignition key to "OFF".
•
After about 4 seconds, the first sequence of 9 flashes has started.
PORTER 1.3 16V Electrical system
ES - 147

PIAGGIO PORTER 1.3 16V 2008 Specifications

General

Brand	PIAGGIO
Model	PORTER 1.3 16V 2008
Category	Automobile
Language	English