PIAGGIO PORTER 1.3 16V 2008 User Manual

Coolant replacement
Check
Check that the coolant level is between the MINI-
MUM and the MAXIMUM reference notches in the
auxiliary reservoir. If the coolant level almost rea-
ches the minimum or is below the MINIMUM level,
add coolant until the MAXIMUM level is reached.
•
NEVER REMOVE THE RADIATOR CAP WHILE
THE ENGINE STILL HOT. FAILURE TO OB-
SERVE THIS SAFETY MEASURE MAY CAUSE
BURNS.
N.B.
•
IF THERE IS NO COOLANT IN THE AUXILIARY
RESERVOIR OR IF THE FLUID LEVEL IS TOO
LOW, CHECK THERE ARE NO WATER LEAKS
USING THE APPROPRIATE TESTER.
•
THE COOLANT SHOULD HAVE A SUITABLE
ANTIFREEZE DEGREE.
N.B.
•
USE A TOP QUALITY ETHYLENE GLYCOL
BASED ANTIFREEZE SOLUTION.
N.B.
•
THE QUANTITY INDICATED ABOVE IN-
CLUDES THE LITRES FOR THE EXPANSION
TANK.
Characteristic
Coolant reservoir capacity:
5.7 litres
Coolant change
NEVER OPEN THE RADIATOR CAP AND/OR THE DRAINAGE PLUG WHEN THE ENGINE IS STILL
HOT.
A. Take the heater control lever to "hot".
B. Remove the radiator cap 3.
C. To drain the coolant, remove the drainage plugs
located on the radiator lower reservoir and the ra-
diator pipe.
D. Remove plug 2 on the engine side and plug 1
of the heater bleed pipe on the upper part of the
engine.
E. Insert a pipe in the radiator fill opening. Clean
the radiator internal side. During this operation
keep the engine at idle speed.
F. Shut off the engine. Refit and close the drainage
plugs.
Maintenance PORTER 1.3 16V
MA - 48

PIAGGIO PORTER 1.3 16V 2008 Specifications

General

Brand	PIAGGIO
Model	PORTER 1.3 16V 2008
Category	Automobile
Language	English