PIAGGIO PORTER 1.3 16V 2008 User Manual

3. Fit the head gasket A, on the centring dowels
inserted in the block.
4. Take the crankshaft to the top dead centre of
cylinders 1-4.
5. Clean the threaded part of the water tempera-
ture sensor.
6. Wrap sealing tape around the threaded part and
fit the sensor in the head-cylinders.
- THE NEW TEMPERATURE SENSOR IS COVERED WITH
A SEALANT LAYER.
THEREFORE, WHEN A SENSOR IS REPLACED, REMOVE
THE SEALANT LAYER BEFORE WRAPPING THE SEAL-
ING TAPE. BESIDES, MAKE SURE THAT THE HOLE OF
THE HEAD THREADED SECTION IS CLEAN.
- THE ORIGINAL SEALANT IS REMOVED BECAUSE AF-
TER BEING STORED FOR A LONG TIME IT HAS LOST ITS
CHARACTERISTICS.
Locking torques (N*m)
Cylinder head - Water temperature sensor 24.5
÷ 34.3
7. Cover each head fixing screw with a thin layer
of engine oil and let it drip.
Fit the head on the block.
N.B.
- BEFORE FITTING THE HEAD, CHECK THE BLOCK.
PORTER 1.3 16V Engine
EN - 285

PIAGGIO PORTER 1.3 16V 2008 Specifications

General

Brand	PIAGGIO
Model	PORTER 1.3 16V 2008
Category	Automobile
Language	English