PIAGGIO PORTER 1.3 16V 2008 User Manual

2. Cover
3. Protection
Checking and adjusting the teeth contact sur-
face between the crown gear and the pinion
1. Apply minium onto both sides of the gear teeth.
Turn the flange to check the teeth contact surface
between the crown gear and the pinion.
NOTE
TURN THE FLANGE IN BOTH DIRECTIONS, AND CHECK THE CONTACT MARK OF TEETH AT
DIFFERENT POINTS.
Select a flat washer with such a thickness so as to
separate the pinion from the crown gear.
Tip contact/Side contact
Select a flat washer with such a thickness so as to
draw the pinion closer to the crown gear.
Rear contact/Front contact
2. Caulk the nut after checking preloadings and the
pinion-crown gear contact surfaces.
Differential PORTER 1.3 16V
DI - 608

PIAGGIO PORTER 1.3 16V 2008 Specifications

General

Brand	PIAGGIO
Model	PORTER 1.3 16V 2008
Category	Automobile
Language	English