Settaggio dei parametri e manutensione
NEW REMOTE CONTROL DETECTION
The central locking system, to work by means of
remote control, must learn the transmission code.
When the vehicle is purchased, the system is pro-
vided with a remote control already working. If the
customer wants a second remote control or looses
the original one, it is necessary to perform a new
transmission code detection procedure. To per-
form this operation correctly, strictly follow the in-
structions indicated below.
New remote control detection procedure:
• Open the glove-box cover.
• Remove the screws fixing the glove-box. The po-
sition of screws is shown in the following figures.
• Remove glove-box extracting it from the instru-
ment panel.
• Identify, the door locking control unit in the glove-
box.
• Remove the door-locking control unit from its
seat so as to be able to reach the cable harness
to which it is connected.
• Identify in the cable harness, a white wire with a
free end.
• Remove the insulating cap from the free end of
the wire.
• Connect the white wire A to the red/white wire
connected to the door locking control unit.
• the vehicle turn indicators flash four times indi-
cating that the detection procedure has started.
• From this time on, the procedure is differentiated
according to the vehicle engine.
PORTER 1.3 16V Electrical system
ES - 129
To Next Page
Loading...
Need help?
General
