Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23 1241
16 Working with the FB Editor
16.8 Copying an interconnection
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
16.8 Copying an interconnection
In contrast to copying/inserting selected interconnection elements via the clipboard, the function
described in this chapter serves to replace the current FB interconnection of a device completely
by
the FB interconnection of another project device.
A complete interconnection comprises:
• Function blocks (use and parameter values)
• System blocks (application and parameter values)
• Port blocks (use and parameter values)
• Connections
•Comments
• Interconnection layout (arrangement of the modules)
• Port definition of the ports used in the FB interconnection
How to copy the complete interconnection into another project device:
1. Select the application with the FB interconnection to be copied in the project view.
2. Select the command Application dataCopy FB interconnections....
3. Go to project view and select the application which is to be inserted into the copied FB
interconnection.
4. Select the command Application dataAdd FB interconnection....
• The command can only be activated if an FB interconnection has been copied from a
device of the same device type and version.
• After the command has been executed, the module assembly is compared. If there are
relevant deviations, the insertion is refused and a corresponding message is displayed.
• If an insertion is possible, you are asked if the FB interconnection is to be inserted.
5. Confirm the question if the copied FB interconnection is to be inserted with Yes.
• After the insertion, an update of the project is required.
Note!
The complete FB interconnection can only be copied between devices of the same device
type and version (e.g. 8400 HighLine C V1.0).
To Next Page
Loading...
Need help?
General
