3 Commissioning
3.10 PC manual control
96
Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.10.5 Positioning (relative or absolute)
Positioning means that a workpiece/tool or material is moved from a starting position to a defined
destination.
A change to the "Positioning" mode and a simultaneous selection of the positioning mode (relative
or absolute) is made by selecting the corresponding option on the Positioning tab:
• The profile parameters stored in the parameter set for the basic "Positioning" function are used:
You can find detailed information on the "Positioning" mode in the chapter entitled
"Basic drive functions" in the subchapter "Positioning
". ( 582)
Parameters Lenze setting Info
Value Unit
Position
(C01301/1...15
)
360.0000 units Target position or distance to be traversed.
• With "Relative positioning": Distance to starting
position (current position).
• With "Absolute positioning": Distance to defined
zero position.
Velocity
(C01302/1...15
)
360.0000 units/s Maximum velocity at which the target is to be
approached.
Acceleration
(C01303/1...15
)
720.0000 units/s
2
Specification of the maximum velocity variation which
is to be used for acceleration.
Deceleration
(C01304/1...15
)
720.0000 units/s
2
Specification of the velocity variation which is to be
used for maximum deceleration to standstill.
S-ramp time
(C01306/1...15
)
0.000 s A profile is traversed with S-shaped ramps by defining
an S-ramp time for it.
Note!
In order that no complex travel movements occur, no switching to a sequence profile
takes place that has been set in the profile data!
You can find detailed information on entering profiles in the chapter entitled "Basic drive
functions", subchapter "Profile entry
". ( 586)
To Next Page
Loading...
Need help?
General
