Lenze 8400 User Manual

Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23 71
3 Commissioning
3.8 Commissioning of the "Table positioning" technology application
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.8.4 Parameterise application
The application parameters can be found on the right side of the Application parameter tab:
1. Select "Table positioning" in the Application list field (C00005
) (if you have not already done
so while creating the project).
After the "Table positioning" application is selected, the contents of the tab change, e.g. the
Machine parameters and Profile entry buttons are shown now.
2. In the Control mode list field (C00007
), the preset "Terminals 0" control mode is already
suitable for the system constellation shown in illustration [3-2]
and need not be changed.
• The corresponding wiring diagram is displayed in a pop-up window if you click the button
right to the list field.
• For a detailed description, see the chapter "Terminal assignment of the control modes
".
( 385)

Lenze 8400 Specifications

General

Category	DC Drives
Series	8400
Protection class	IP20
Control Type	Vector control
Communication	CANopen, PROFIBUS, Ethernet
Protection Features	Overcurrent, overvoltage, undervoltage, overtemperature
Input Voltage	AC 230/400/480 V