Lenze 8400 User Manual

15 Parameter reference
802 Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
15 Parameter reference
This chapter describes all parameters which can be used for parameterising and monitoring the
inverter.
Parameters which are only available in the inverter from a certain software version onwards are
marked with a corresponding note in the parameter description ("from version xx.xx.xx").
The parameter descriptions are based on software version V16.00.00
 Tip!
For quick reference of a parameter with a certain name simply use the index of the online
documentation. The index always contains the corresponding code in parentheses behind
the name.
General information on parameter setting can be found in the chapter "Introduction:
Parameterising the inverter". ( 27)
For general information on how to read and change parameters, please see the online
documentation for the »Engineer«.

Lenze 8400 Specifications

General

Category	DC Drives
Series	8400
Protection class	IP20
Control Type	Vector control
Communication	CANopen, PROFIBUS, Ethernet
Protection Features	Overcurrent, overvoltage, undervoltage, overtemperature
Input Voltage	AC 230/400/480 V