Lenze 8400 User Manual

Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23 715
11 System bus "CAN on board"
11.8 Process data transfer
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
11.8 Process data transfer
[11-5] PDO data transfer from / to the higher-level host system
For transmitting process data, up to four separated process data channels (PDO1 ... PDO4) are
available depending on the device version and software version.
Definitions
• Process data telegrams between the host system and the devices are distinguished in terms of
direction as follows:
• Process data telegrams to
the device (RPDO)
• Process data telegrams from
the device (TPDO)
• The CANopen process data objects are designated as seen from the node's view:
• Receive PDOs (RPDOx): Process data object received by a node
• Transmit PDOs (TPDOx): Process data object sent by a node
 Note!
Data can only be exchanged via process data objects if the status is "Operational"!
Communication phases/network management
( 711)

Lenze 8400 Specifications

General

Category	DC Drives
Series	8400
Protection class	IP20
Control Type	Vector control
Communication	CANopen, PROFIBUS, Ethernet
Protection Features	Overcurrent, overvoltage, undervoltage, overtemperature
Input Voltage	AC 230/400/480 V