Lenze 8400 User Manual

Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23 365
6 I/O terminals
6.6 User-defined terminal assignment
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.6 User-defined terminal assignment
In order to individually adapt the preconfigured assignment of the input/output terminals to your
application, you can choose one of the following procedures:
A. In the »Engineer«:
• Change the terminal assignment on the Terminal assignment tab.
• Change the signal assignment on the Application Parameters tab, on the dialog level
Overview  Signal flow.
• Change the interconnections in the FB editor (on the I/O level).
B. In the »Engineer« or with the keypad:
• Change the parameters for signal configuration in the parameters list.
 Tip!
First of all, select a Lenze configuration useful for the purpose at hand by going to C00005
and selecting a technology application that matches your drive task and then going to
C00007
and selecting an appropriate control mode. You will then have an application for
which there is a signal flow, logical block links and terminal assignment.
We recommend using the »Engineer« for the implementation of comprehensive user-
defined drive solutions.
 Note!
If you change the preconfigured assignment of the input/output terminals, the terminal
assignment will be a user-defined one. In C00007
, control mode "0: Interconnection
changed" will be shown.

Lenze 8400 Specifications

General

Category	DC Drives
Series	8400
Protection class	IP20
Control Type	Vector control
Communication	CANopen, PROFIBUS, Ethernet
Protection Features	Overcurrent, overvoltage, undervoltage, overtemperature
Input Voltage	AC 230/400/480 V