February, 2008
4-226
WorkCentre 5225, 5230
ADJ 9.3.1
Launch Version
Repairs and Adjustments
ADJ 9.3.1 Firmware Version Downloading
Purpose
The purpose is to load software in the ESS PWB, FCB PWB, IIT/IPS PWB, DADF PWB ROM.
NOTE: Software can be loaded utilizing any of the three ports.
• USB port
• Network port
• Parallel port
M123 USB Port
NOTE: If PWS has Windows 98 operating system then refer to Firmware Upload Utility CD for
detailed instructions on how to enable the USB port on the PWS.
1. Print out a System Settings List (GP 5 Printing Reports) to compare options at the com-
pletion of the download.
2. Power off the Machine and the PWS.
3. Remove the ESS cover and plug the USB cable into the USB port on the ESS PWB and
to your PWS.
4. Power on the Machine into the Download Mode. (Hold the Power Saver Button down
while powering on the Machine)
5. Power on the PWS.
6. A “Device Found” window will pop-up on your PWS. Select Cancel on this pop-up.
7. Open the PWS Firmware Update Tool. (FWDLMgr.exe)
8. Click on Agree in the License Screen.
9. On the Firmware Update Tool screen select the following:
Printer Model: CopyCentre/ WorkCentre M123 or 128 as appropriate.
File name: Click on Browse. (On the next screen you need to find the.bin file to Download.
The file should read either: SHXC_STDXXXXX.bin for WorkCentre machines or
SHXC_PSXXXXX.bin for WorkCentre Pro machines that have the PostScript option. The
X's in the file indicate the version. Highlight the file that you want and click on Open.)
Click on Add once you have found the File name.
Click on Version to check the version of the software you are about to download.
10. Click on Next.
11. In the Firmware Update Tool select USB port.
12. Click Next.
13. The Download will start and takes approximately 20 minutes.
14. The PWS will Transfer the file to the machine in about 3 minutes. Do not unplug the USB
cable until the download is complete.
On the PWS you will see - IIT Finish, ADF Finish, Finisher Finish etc. as the machine
unpacks each piece of the firmware.
On the machine you will see “TRANSFERRING” as the file is transferred, then “PRO-
CESSING”, 0-5 progressing to 4-5 as the file is unpacked.
15. The Machine will reboot and come up to the Ready to Copy Mode when finished.
16. On the PWS select Finish and Click Yes, exit the program.
17. The Software Download is now complete.
18. Compare a new System Settings List (GP 5 Printing Reports) to the one printed at the
start of the instructions and enable any Options needed.
To Next Page
Loading...
Need help?
General
