EasyManuals Logo
Home>Xerox>All in One Printer>WorkCentre 5230

Xerox WorkCentre 5230 User Manual

Xerox WorkCentre 5230
1457 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #620 background imageLoading...
Page #620 background image
February, 2008
2-597
WorkCentre 5225, 5230
116-334, 116-335
Status Indicator Raps
Launch Version
116-334 ESS NVRAM Data Compare Fail RAP
System Cont detects [ESS-NVRAM with factory settings is installed] or [Illegal ESS-NVRAM
data is occurring].
Initial Actions
Power Off/On
Procedure
As powering OFF then ON after a detection of 116-334 will presumably cause other errors 124-3xx
that indicate various data mismatches between the three locations, resolve one(s) following the
corrective actions for the relevant Fault Code(s).
If 116-334 reoccurs despite powering OFF/ON, disconnect and reconnect the NV-RAM Board,
then turn ON the power.
If the problem persists, replace the NV-RAM Board.
If the problem still persists, replace the mercury battery.
116-335 HDD RAP
The control logic detected that the HDD failed.
Initial Actions
Power Off/On
Procedure
Check the HDD electrical connections (PL 9.2).
If the problem persists perform Hard Disk Diagnostic Program.
If the problem persists replace the HDD (PL 9.2).

Table of Contents

Other manuals for Xerox WorkCentre 5230

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox WorkCentre 5230 and is the answer not in the manual?

Xerox WorkCentre 5230 Specifications

General IconGeneral
Maximum print sizeA3 (297 x 420 mm)
Standard input capacity500 sheets
Internal memoryNo MB
TypeDigital copier

Related product manuals