February, 2008
4-156
WorkCentre 5225, 5230
REP 16.2.18, REP 16.2.19
Launch Version
Repairs and Adjustments
REP 16.2.18 Eject Belt
Parts List on PL 23.13
Removal
WARNING
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Undock the Finisher. (REP 16.2.1)
2. Remove the Booklet Maker. (REP 16.3.2)
3. Remove the Rear upper Cover. (REP 16.2.3)
4. Remove the Eject Motor Assembly. (REP 16.2.19)
5. Remove the Eject Motor. (REP 16.2.23)
6. Remove the Eject Belt.
Replacement
1. To install, carry out the removal steps in reverse order.
REP 16.2.19 Eject Motor Assembly
Parts List on PL 23.11
Removal
WARNING
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Undock the Finisher. (REP 16.2.1)
2. Remove the Booklet Maker. (REP 16.3.2)
3. Remove the Rear Upper Cover. (REP 16.2.3)
4. Preparing to remove the Eject Motor Assembly.
a. Disconnect the Eject Motor connector
b. Remove the wire harness from the Harness Guide
c. Disconnect the wire harness clamps (2)
d. Remove the screws (2) from the Harness Guide and move the Harness Guide aside.
e. Disconnect the Spring
f. Remove the Eject Motor Assembly screws (4)
5. Remove the Eject Motor Assembly.
Replacement
1. To install, carry out the removal steps in reverse order.
To Next Page
Loading...
Need help?
General
