2008T Troubleshooting Guide
P/N 490292 Rev. A
BL- 3.0.0 AIR SEEN
Per the Figure right, using a flashlight, are air bubbles MOVING
into the machine through the clear acid and / or bicarb Inlet
Tubing?
Yes Air seen! A) If using a jugs ensure they are full AND the
wands reach the bottom of the jugs; B) Check the acid
and / or bicarb connector’s O-rings and plug; C) Check
the pickup wand(s) tubing.
No air seen! See procedure number BL- 3.0.1 (page 559).
BL- 3.0.1 ISOLATE AIR REMOVAL SYSTEM
a) Turn the water off and allow a “No Water” alarm to occur!
b) The Deaeration gauge is used next. ENSURE it reads 0 inHg
before installing it!
c) Allow one (1) minute for the deaeration motor to stop running!
d) Figure right, tee the gauge to the INPUT (clear tubing) of the
Deaeration Pump.
e) Turn the water on and allow the “No Water” alarm to go away!
f) Is Deaeration Pressure OKAY? Refer to Appendix A (page 757) for what pressure should be.
Yes Deaeration Pressure is OKAY! See procedure number BL- 3.0.4 (page 559).
No Deaeration Pressure in NOT OKAY! ENSURING a “No Water” alarm is NOT occuring,
NOTE this page number, as you will return here, THEN proceed to page 543, SECTION
13 - DEAERATION PROBLEMS.
BL- 3.0.4 DEAERATION PRESSURE OKAY
a) Turn the water OFF and allow a “No Water” alarm to occur!
b) Allow one (1) minute for the deaeration motor to stop running!
c) Remove the gauge and reattach the tubing.
d)
Turn the water on and allow the “No Water alarm to go away!
e) See procedure number BL- 3.0.5 (page 560).
To Next Page
Loading...
Need help?
General
