2008T Troubleshooting Guide
P/N 490292 Rev. A
 The 5-pin female connectors can be unplugged and returned with the
power on without causing damage

CAUTION! The green 8-pin Heater Connector (Figure right) is connected
to 120 Volts AC.
Figure 1 – Distribution Board
M. Figure below, if asked to measure DC voltages (V
DC
) and in some cases resistance (Ω) connect the
meter’s ground (black) lead to the card cage (i.e. chassis ground).
Figure 2 – Chassis Ground
N. Procedures may vary depending on if the machine is equipped for bibag. See the following page:
To Next Page
Loading...
Need help?
General
