2008T Troubleshooting Guide
P/N 490292 Rev. A
V104SC- 2.0.1 ISOLATE LOADING PRESSURE
A) Figure right, remove the ACID (RED) connector
from the acid inlet tubing AND attach the Loading
Pressure gauge tubing to it
.
B) Place the Acid Inlet tubing into water.
C)
ENSURE the gauge reads 0 psi before inserting it in
the Rinse Port!
D) Figure below, right SLAM the acid connector into
the Acetate/Acid Rinse port.
E)
Return to RINSE! NOTE! Ignore vent tubing overflow for now.
F) Watch the gauge for one (1) minute as it may cycle below 15 psi at times but does it EVER PEAK to at
least 23 psi?
Yes Cycles to at least 23 psi! Continue to part G next page!
No NEVER cycles to at least 23 psi! TWO (2) possible scenarios below:
1) IF REMAINS ALWAYS less than 15 psi: Proceed to page 174, procedure number
CLEAN- 1.2.33.
2) IF CYCLING to between 15 and 21 psi: Adjust Valve #65* attempting to achieve a PEAK of
between 23 and 25 psi. * To LOCATE Valve #65 refer to Figure 6 (page 22). TWO (2)
possible scenarios I or II below:
I. IF (and ONLY if) unable to adjust to at least 23 psi: Proceed to
page 174,
procedure number CLEAN- 1.2.33
II. IF you can adjust to between 23 and 25 psi: Perform parts a THROUGH c below:
a) Return the red connector to the acid inlet tubing.
b) Return to RINSE!
c) Call debug screen 15. If Bic Press is achieving POSITIVE 400 this may have
solved the problem! If Bic Press still is not achieving 400 see part G next page.
To Next Page
Loading...
Need help?
General
