February 2013
4-385
ColorQube® 9303 Family
REP 94.1
Repairs/Adjustments
REP 94.1 Cleaning Unit
Parts List on PL 94.10.
Removal
Use this repair when replacing a cleaning unit that has failed.
WARNING
Immediately clean an oil spill. Spilt oil is a slip hazard. Do not walk in the contaminated
area. Walking in the contaminated area will spread the contamination and contaminate
footwear. Contaminated footwear is a slip hazard.
WARNING
Do not attempt to mop up the spilt oil with conventional mops and water. This will
spread the contamination and will extend the slip hazard.
1. If fault codes 94-611-00, 94-616-00 or 94-629-00 are present, the cleaning unit has failed
in a way that may have spilled oil inside the machine, continue at step 2. Otherwise, con
-
tinue at step 3.
2. Prepare an area in front of the machine by placing a barrier layer over the customer floor.
3. Remove the new cleaning unit from the shipping box. Take care not to damage the zipper
bag. Place the new cleaning unit away from any oil contamination.
4. The failed cleaning unit must be removed from the machine with extreme care to prevent
oil dripping onto the customers floor. If the cleaning unit is locked in place and cannot be
removed, go to GP 36 and unlock the cleaning unit.
5. Place the failed cleaning unit into the zipper bag and seal the bag with the zip. Place the
failed cleaning unit into the shipping box. Follow the instructions included in the shipping
box to return the failed cleaning unit. Use the shipping label supplied in the shipping box.
6. Inspect the chassis pan directly below the cleaning unit cavity for a pool of oil. A thin film
of oil is normal. Clean up any oil pool, GP 27 Cleaning Procedure.
Replacement
Install the new cleaning unit.
To Next Page
Loading...
Need help?
General
