Xerox ColorQube 9303 Series Service Manual

February 2013
4-47
ColorQube® 9303 Family
REP 5.9, REP 5.10
Repairs/Adjustments
REP 5.9 DADH Tray Size Sensors
Parts List on PL 5.35
Removal
WARNING
Switch off the electricity to the machine. Refer to GP 14. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the input tray assembly, REP 5.4.
CAUTION
Disconnect the ground harness from the static eliminator before the input tray assembly lower
cover is removed, refer to Figure 1.
2. Turn the input tray assembly upside down, then remove the Lower cover right, PL 5.35
Item 9.
3. Remove the relevant sensor, Figure 1.
Figure 1 Tray size sensors
Replacement
The replacement is the reverse of the removal procedure.
REP 5.10 Registration Sensor
Parts List on PL 5.25
Removal
WARNING
Switch off the electricity to the machine. Refer to GP 14. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the DADH, top cover assembly, REP 5.1.
2. Remove the registration sensor, Figure 1.
Figure 1 Registration sensor
Ground harness.
See CAUTION.
2
Disconnect the correct PJ. Remove
the correct sensor.
Sensor 1.
Sensor 2.
1
Remove the ground harness
and bracket.
1
Remove 2 screws.
2
Carefully release the
torsion spring.
3
Remove the pre-scan
idler roll.
4
Remove the sensor assembly.
5
Disconnect PJ192. Remove
the registration sensor

Xerox ColorQube 9303 Series Specifications

General

Brand	Xerox
Model	ColorQube 9303 Series
Category	All in One Printer
Language	English