February 2013
6-256
ColorQube® 9303 Family
dC134, dC135
General Procedures/Information
dC134 Market Region
Purpose
NOTE: This procedure is only applicable to machines with software versions
071.XXX.XXX.XXX or higher
To provide the option to select and set an interminable market region for the machine.
Procedure
1. Enter service mode, GP 1.
2. Select the maintenance tab.
3. Select dC134 Market Region from the scroll list.
4. Select the 0 - US button for operation in North America or Canada.
Select the 5 - Europe button for operation in all other market regions.
5. Select Save.
6. Select Close to exit routine.
7. Select Call Closeout to exit service mode.
8. To apply the change, select Exit and Reboot.
dC135 CRU/HFSI Status
Purpose
To view the counters for customer replacement units and high frequency service items indicat-
ing the type, name and percent remaining.
There are two types of CRU’s. Some of the CRU’s are equipped with CRU Manager (CRUM)
chips that are used for the management of data relevant to that particular CRU. Other CRU’s
do not have CRUMs; the management of these consumables is dependant upon the user to
confirm replacement.
ERU’s – Engineer Replaceable Units. These are typically replaced by service technician, and
do not trigger user warnings as end of life is reached. Of these, some are classified as HFSI’s
– High Frequency Service Items, meaning that it can be anticipated that these will need to be
replaced at some point during the normal life expectancy of the machine.
Procedure
1. Enter service mode, GP 1.
2. Select the Service Info tab.
3. Select dC135 CRU / HFSI.
4. Refer to Table 1 to observe the status of the items.
5. To reset the HFSI File:
a. Select the HFSI item.
b. Select Reset HFSI.
c. Select Reset to confirm.
6. Select Close to exit the routine.
7. Select Call Closeout to exit service mode.
To Next Page
Loading...
Need help?
General
