February 2013
4-107
ColorQube® 9303 Family
REP 12.6-110, REP 12.7-110
Repairs/Adjustments
Replacement
NOTE: Ensure that the slots in the tamper assembly locate correctly in the LCSS frame.
NOTE: Ensure that the sensors are correctly located in the tamper assembly, they are easily
mis-located when being re-connected to the harnesses.
NOTE: Ensure that all connectors in the harness over the tamper assembly are securely con-
nected.
Reverse the removal procedure to replace the tamper assembly.
REP 12.7-110 Hole Punch Unit, Motor and Sensors
Parts List on PL 12.20.
Removal
WARNING
Switch off the electricity to the machine. Refer to GP 14. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the LCSS covers, REP 12.1-110.
2. Remove and empty the chad bin, PL 12.20 Item 4.
To Next Page
Loading...
Need help?
General
