February 2013
6-126
ColorQube® 9303 Family
dC108, dC113
General Procedures/Information
dC108 Software Version
Purpose
To identify the version of the installed software on all major modules.
Procedure
1. Enter Service Mode, GP 1.
2. Select the Service Info tab.
3. Select dC108 Software Versions.
The dC108 Software Versions screen will display the software and version numbers
installed on the machine.
4. Select Close to exit the routine.
5. Select Call Closeout to exit Service Mode.
dC113 Fast Time to Ready
Purpose
dC113 Fast Time to Ready avoids waiting for the IME to heat-up the ink system.
When dC113 is selected the heaters will still come up to printing temperature but functions that
would not normally be enabled are made available before printing temperature is reached.
Procedure
1. Enter Service Mode, GP 1.
2. Select the Service Info tab.
3. Select dC113 Fast Time to Ready. The UI shows The machine is offline.
NOTE: dC113 Fast Time to Ready Mode has the following characteristics:
• When dC113 is selected, no routine or further settings are displayed.
• Selecting dC113 after the machine has warmed up will have no effect on the
machine except that the dC113 list item will become greyed out. When the heaters
are up to temperature the feature has no function.
• When dC113 has been selected the warming up message is no longer displayed.
When Service Mode is exited the status region displays a message indicating that
scanning and printing are available.
• dC113 can only be selected once for each power on cycle and once selected it can-
not be cancelled.
4. Select Close to exit the routine.
5. Select Call Closeout to exit Service Mode.
To Next Page
Loading...
Need help?
General
