February 2013
6-258
ColorQube® 9303 Family
dC136, dC137
General Procedures/Information
dC136 Service Plan
Purpose
To allow the service plan to be changed from metered to sold. An authorization code is
required from the Xerox service centre.
Procedure
1. Enter service mode, GP 1.
2. Select the Maintenance tab.
3. Select dC136 Service Plan.
The service plan information is displayed.
4. Enter the authorization code to change the service plan.
NOTE: The authorization code generator can be down loaded from GSN library 10480.
NOTE: The service plan can be changed from and to any service plan.
5. Select Close to exit routine.
6. Select Call Closeout to exit service mode.
7. To apply the change switch the machine off and switch the machine on again, GP 14.
dC137 Page Pack
Purpose
To enable or disable the page pack function. When enabled the page pack function, a cus-
tomer typically pays a fixed amount per month, or per page, for supplies and / or service plan.
Procedure
1. Enter service mode, GP 1.
2. Select the Maintenance tab.
3. Select dC137 Page Pack.
The Page Pack screen is displayed.
NOTE: The page pack function is only enabled in XE installations. Depending on the cus-
tomer's full service maintenance agreement, the page pack function needs to be enabled
when a USSG/XCL machine is installed in an XE region.
4. Select Disabled or Enabled.
5. Enter the PagePack passcode, a 4 digit authorization code. The authorization code can
be found in the customers machine installation pack.
6. The Save button will appear. Select Cancel or Save.
7. Select Call Closeout to exit service mode.
To Next Page
Loading...
Need help?
General
