Xerox ColorQube 9303 Series Service Manual

February 2013
4-387
ColorQube® 9303 Family
ADJ 4.1
Repairs/Adjustments
ADJ 4.1 Machine Lubrication
Purpose
To correctly lubricate the machine to prevent noise and wear.
Lubrication
Refer to GP 18 Machine Lubrication for general guidance on the use of lubricants.
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
The following list gives the parts of the machine where lubrication is permitted. Go to the rele-
vant procedure:
• LCSS Drive Belt Tensioners.
• LCSS Bin 1 Drive Belt Pulleys and Idler.
• LCSS Bin 1 Elevator Motor Worm and Gear.
• LCSS Tamper Assembly.
• HVF BM Support Pin.
LCSS Drive Belt Tensioners
1. Remove the LCSS top cover and rear cover, REP 12.1-110.
2. Remove the relevant belt tensioner:
• Intermediate paper drive belt tensioner, PL 12.60 Item 17.
• Bin 1 drive belt tensioner, PL 12.30 Item 13.
3. Remove the E-clip and pulley from the belt tensioner. Apply plastislip grease, PL 26.10
Item 4 to the shaft and pulley bore. Re-assemble the pulley and E-clip on the belt ten
-
sioner.
4. Clean off the old lubricant and any contamination from the belt tensioner and LCSS frame
using a micro fiber wiper, PL 26.10 Item 6. Apply Molub grease 777, PL 26.10 Item 12, to
the whole contact face of the belt tensioner.
5. Reinstall the belt tensioner.
LCSS Bin 1 Drive Belt Pulleys and Idler
1. Remove the LCSS top cover and rear cover, REP 12.1-110.
2. Remove the relevant pulley or idler:
• Bin 1 drive belt idler, PL 12.30 Item 1.
• Bin 1 drive belt pulleys, PL 12.30 Item 6.
3. Remove the E-clip and pulley or idler from the belt tensioner. Apply plastislip grease, PL
26.10 Item 4 to the shaft and pulley or idler bore. Re-assemble the pulley or idler and E-
clip on the belt tensioner.
4. Reinstall the belt tensioner.
LCSS Bin 1 Elevator Motor Worm and Gear
1. Remove the LCSS top cover and rear cover, REP 12.1-110.
2. Use plastislip grease, PL 26.10 Item 4, to lubricate the worm and gear on the Bin 1 eleva-
tor home motor, PL 12.30 Item 8.

Xerox ColorQube 9303 Series Specifications

General

Brand	Xerox
Model	ColorQube 9303 Series
Category	All in One Printer
Language	English