February 2013
6-98
ColorQube® 9303 Family
GP 34
General Procedures/Information
GP 34 Service Plan
Purpose
To change the machine service plan from metered to sold.
Description
On receiving the change of contract request, the CCS validates the authorization code to
change the service contract from metered to sold. The CCS updates and saves the new ser
-
vice contract in the CCS NVM.
Procedure
WARNING
Switch off the electricity to the machine. Refer to GP 14. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
To change the service plan, go to dC136.
Refer to dC131 CCS NVM 606-269 and use Table 1 to identify which plan the machine is cur-
rently on.
Key plate Adapter Locations
To identify which ink stick locates into the corresponding key plate. These illustrate the notches
and shapes present that suit the specification of each plan.
• Xerox North America / Europe Sold (XNA / EU Sold) Figure 1.
• Worldwide Metered Figure 2.
•DMO Sold Figure 3.
Figure 1 Xerox North America / Europe Sold
Figure 2 Worldwide Metered
Table 1 Service plan
Item #
Type of Service
Plan
Service Plan
which can be
changed
Service Plan which cannot be
changed
1. Sold = 0 Xerox Managed
Supplies = 3
Page Pack = 4, DMO Sold = 5
2. Non Sold = 1 Sold = 0 Third Party = 2
Xerox Managed Supplies = 3
Page Pack = 4, DMO Sold = 5
3. Third Party = 2 Not applicable Sold = 0, Non Sold = 1,
Xerox Managed Supplies = 3
Page Pack = 4, DMO Sold = 5
4. Xerox Managed
Supplies = 3
Sold = 0 Non Sold = 1, Third Party = 2
Page Pack = 4, DMO Sold = 5
5. Page Pack = 4 Sold = 0 Non Sold = 1, Third Party = 2
Xerox Managed Supplies = 3
DMO Sold = 5
6. DMO Sold = 5 Not Applicable Sold = 0, Non Sold = 1, Third Party = 2
Xerox Managed Supplies = 3
Page Pack = 4
1 Dot
15 mm
3 Dots
To Next Page
Loading...
Need help?
General
