Siemens SCALANCE XR-500 Configuration Manual

Configuration
3.2 Load and Save
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
104 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call up the command with the following parameters:
load tftp {ipv4 <ucast_addr> | fqdn-name <FQDN> | ipv6 <ip6_addr>} [port <tcp port
(1-65535)>] file <filename> filetype <filetype>
The parameters have the following meaning:
Parameter
Description
Range of values / note
ipv4
Keyword for an IPv4 address
ucast_addr
IPv4 unicast address of the TFTP
server
Enter a valid unicast IPv4 ad-
dress.
fqdn-name
Keyword for a domain name
-
FQDN
Domain name (Fully Qualified Domain
Name) of the TFTP server
Maximum of 100 characters
ipv6
Keyword for an IPv6 address
-
ip6_addr
IPv6 address of the TFTP server Enter a valid unicast IPv6 ad-
dress.
port
Keyword for the port of the server via
which the TFTP connection runs
-
tcp port
Number of the port
1 … 65535
file
Keyword for a file name to be assigned
-
filename
Name of the file
Maximum of 100 characters
filetype
Keyword for the file type to be loaded
-
filetype
Name of the file type
Maximum of 100 characters
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
For information on the file types , refer to this list (Page 101).
Result
The file is loaded on the device from the TFTP server.
3.2.3
save filetype
Description
With this command, you save files on a TFTP server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English