Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
530 Configuration Manual, 11/2015, C79000-G8976-C252-10
no redistribute
Description
With this command, you disable distribution of routes with OSPFv3.
Note
This command is available only with layer 3.
● The router is an ASBR router.
● You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Call up the command with the following parameters:
no redistribute {static | connected | ripng | bgp }
The parameters have the following meaning:
The routes are specified that are not distributed via OSPFv3.
You enable the ASBR router with the ASBR Router command.
You enable the distribution of the routes with the
redistribute command.
You display the setting with the
show ipv6 ospf command.
To Next Page
Loading...
Need help?
General