Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
633
Call up the command with the following parameters:
no match interface {Vlan < vlan-id(1-4094)> | <interface-type> < interface-id> }
The parameters have the following meaning:
Keyword for a VLAN connection 1 ... 4094
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the
interface
The filter for the interface is deleted.
You create a filter for an interface with the match interface command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
With this command, you specify whether or not the routing information for a route map is
filtered based on the value of the metric.
Note
This command is available only with layer 3.
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
To Next Page
Loading...
Need help?
General