Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
488 Configuration Manual, 11/2015, C79000-G8976-C252-10
The interval is specified.
You delete the interval with the no ip ospf dead-interval command.
You show the configuration of the OSPF interface with the
show ip ospf interface
command.
no ip ospf dead-interval
Description
With this command, you delete the interval.
Note
This command is available only with layer 3.
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Call the command without parameter assignment:
no ip ospf dead-interval
The interval is deleted.
You specify the interval with the ip ospf dead-interval command.
You show the configuration of the OSPF interface with the
show ip ospf interface
command.
You configure the router port with the
no switchport command.
To Next Page
Loading...
Need help?
General