Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
504 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
show ipv6 ospf neighbor [ <Neighbor-RouterID> ]
The parameter has the following meaning:
Router ID of the neighbor Specify the ID
If you do not enter a router ID, information on all neighbor routers that can be reached via
the link is shown.
The information is displayed.
show ipv6 ospf redist-config
Description
This command shows the information that is distributed via the routes of the routing table.
Note
This command is available only with layer 3.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameter assignment:
show ipv6 ospf redist-config
The information is displayed.
To Next Page
Loading...
Need help?
General