Siemens SCALANCE XR-500 Configuration Manual

Network protocols
7.11 ARP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
379
Syntax
Call up the command with the following parameters:
show ip arp [{Vlan<vlan-id(1-4094)>|<interface-type><interface-id>|
<ip-address>|<mac-address>|summary|information}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
Vlan
Keyword for a VLAN connection
-
vlan-id
Number of the addressed VLAN 1 ... 4094
interface-type
Type or speed of the interface
Enter a valid interface.
interface-id
Module no. and port no. of the interface
ip-address
Shows the IP addresses of the entries
in the ARP table
-
mac-address
Shows the MAC addresses of the en-
tries in the ARP table
-
summary
Shows a summary of the entries in the
ARP table
-
information
Displays information on the ARP con-
figuration
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, the IP ARP table is displayed.
Result
The IP ARP table is displayed.
7.11.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
7.11.2.1
arp
Description
With this command, you generate a static entry in the ARP cache.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English