Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
204 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call the command without parameters:
transparent-vlan
The VLAN is changed to transparent mode.
● All ports that were not members or untagged members in the relevant VLAN are
automatically set to the Forbidden status after the command executes.
● As long as a VLAN is configured as a transparent VLAN, the ports belonging to this VLAN
cannot be modified.
● Note that only one VLAN can be configured as a transparent VLAN.
You disable the setting with the
no transparent-vlan command.
no transparent-vlan
Description
With this command, you return a VLAN from the transparent mode to the mode conforming
with the standard.
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Call the command without parameters:
no transparent-vlan
If the VLAN was configured as a transparent VLAN, this function is deactivated.
This means the following:
● All transparent ports become untagged members in this VLAN
● The port VLAN ID of the previous transparent ports remains set to the ID of this VLAN.
● All other ports remain marked as forbidden in this VLAN.
To Next Page
Loading...
Need help?
General