Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
632 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
match interface {Vlan < vlan-id(1-4094)> | <interface-type> < interface-id> }
The parameters have the following meaning:
Keyword for a VLAN connection 1 ... 4094
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the
interface
The filter for the interface is created.
You delete the filter for the interface with the no match interface command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
no match interface
Description
With this command, you delete the filter for the interface.
Note
This command is available only with layer 3.
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
To Next Page
Loading...
Need help?
General