Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
509
Requirement
● IPv6 routing is activated.
● You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ipv6 router ospf
Result
Routing with OSPFv3 is enabled.
You are now in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli (config-ospfv3)#
Further notes
You disable routing with OSPFv3 with the no ipv6 router ospf command.
You enable IPv6 routing with the
ipv6 unicast-routing command.
9.3.2.2
no ipv6 router ospf
Description
With this command, you disable routing with OSPFv3.
Note
This command is available only with layer 3.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ipv6 router ospf

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English