Siemens SCALANCE XR-500 Configuration Manual

Configuration
3.3 Reset and Defaults
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
112 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call up the command with the following parameters:
tftp server {ipv4 <ucast-addr> | fqdn-name <FQDN> | ipv6 <ip6_addr>} [port <tcp
port(1-65535)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
ipv4
Keyword for an IPv4 address
-
ipv4-address
Value for an IPv4 unicast address Enter a valid IPv4 unicast ad-
dress.
fqdn-name
Keyword for a domain name
-
FQDN
Domain name (Fully Qualified Domain
Name)
Maximum of 100 characters
ipv6
Keyword for an IPv6 address
-
ip6_addr
Value for an IPv6 unicast address Enter a valid IPv6 unicast ad-
dress.
port
Keyword for the port of the server via
which the TFTP connection runs
-
tcp port
Number of the port
1 … 65535
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The settings for the access to the selected TFTP server are configured.
3.3
Reset and Defaults
This section describes commands for restarting the device and for restoring the original
configuration.
3.3.1
restart
Description
With this command, you restart the device.
Select one of the following configuration settings:
● Device restart with the current configuration
● Device restart with the factory configuration settings.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English