Functions specific to SCALANCE
4.4 Signaling contact
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
141
The function of the "SELECT/SET" button for setting the fault mask is enabled or disabled.
This section describes the commands relevant for working with the signaling contact.
This section describes commands with which you display various settings.
show signaling contact
Description
This command shows the current configuration of the signaling contact.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show signaling-contact
The current configuration of the signaling contact is displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
To Next Page
Loading...
Need help?
General