Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
176 Configuration Manual, 11/2015, C79000-G8976-C252-10
show vlan port config
Description
This command shows the VLAN-specific information for ports.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show vlan port config[{port<interface-type><interface-id>}]
The parameters have the following meaning:
Enter a valid interface.
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, the entries of all available
interfaces are displayed.
The information about the ports is displayed.
show vlan protocols-group
Description
This command displays the table with the protocol group entries.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General