Siemens SCALANCE XR-500 Configuration Manual

Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
195
6.1.3.11
switchport priority default
Description
With this command, you configure the priority default for the interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport priority default <0-7>
The parameter has the following meaning:
Parameter
Description
Range of values / note
-
Value for the priority default 0 ... 7
Default: 0
Result
The setting for the default priority of the interface is configured.
Further notes
You reset the priority default to the original default with the no switchport priority default
command.
You display this setting and other information with the
show vlan port config command.
6.1.3.12
no switchport priority default
Description
With this command, you reset the priority default for the interface to the default value.
The default value is 0.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#

Siemens SCALANCE XR-500 Specifications

General

Product function / VLAN	Yes
Port Types	Ethernet
Operating voltage / rated value	24 V DC
Supply voltage / 1	24 V DC
Type of voltage / 1 / of the supply voltage	DC
Operating Temperature	-40 ... 70 °C
Mounting Type	Wall mounting, DIN rail mounting
Mounting	DIN rail, wall mounting
Protocol Support	SNMP
Redundancy	Yes
Certifications	UL, CE, FCC, ATEX, IECEx