Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
557
You are in the VRRP Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-if)#
Call up the command with the following parameters:
vrrp <vrid(1-255)> associated-ip <ip_addr>
The parameters have the following meaning:
Value for an IPv4 address Enter a valid IPv4 address.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The IPv4 addresses are specified.
You can create a maximum of 52 virtual IP addresses.
You configure a VRRP interface with the
interface command.
You remove an IPv4 address with the
no vrrp associated-ip command.
You remove all IPv4 addresses with the
vrrp group shutdown command.
You display the IPv4 addresses with the
show vrrp interface - vrid command.
no vrrp associated-ip
Description
With this command, you remove an IPv4 address from the virtual router.
Note
This command is available only with layer 3.
You are in the VRRP Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-if)#
To Next Page
Loading...
Need help?
General