Layer 2 management protocols
8.1 GARP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
388 Configuration Manual, 11/2015, C79000-G8976-C252-10
show forward-unregistered
Description
With this command, you display the entries of the GMRP forward unregistered table.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show forward-unregistered
The entries of the GMRP forward unregistered table are displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
With this command, you enable the GMRP function for all or individual interfaces on the
device.
You are in the Global configuration mode
or
You are in the Interface configuration mode
The command prompt is as follows:
cli(config)#
cli (config-if-$$$) #
To Next Page
Loading...
Need help?
General