Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
442 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
show ip ospf
[area-id]
database
[{
database-summary|self-originate|adv-router <ip-address>
}]
The parameters have the following meaning:
Area-ID specify an ID.
x.x.x.x
x = 0 ... 255
Number of LSA types per area and the
total number of areas
-
Number of LSAs generated by the local
router.
-
Keyword for the router-specific LSA
shows the router-specific LSA for a
specific IP address
specify a valid IP address.
If no IP address is entered, the
specific LSAs of the local router
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The summary of the database is displayed.
show ip ospf ... database ...
Description
This command shows information about a specific or all LSA types.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General