Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
446 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
show ip ospf neighbor
[{
vlan <vlan-id(1-4094)>|<interface-type><interface-id>
}]
[Neighbor ID]
[detail]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN 1 ... 4094
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
Router ID of the neighbor The ID consists of 4 numbers
each between 0 and 255 and can
match the IP address of the rout-
OSPF information on the neighbor
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The information on the neighboring routers is displayed.
show ip ospf request-list
Description
This command shows the request list. This request list contains the information required for
the LSAs.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General