Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
458 Configuration Manual, 11/2015, C79000-G8976-C252-10
With this command, you configure areas of the type NSSA (not-so-stubby-area).
Note
This command is avail
able only with layer 3.
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Call up the command with the following parameters:
area <area-id> nssa
[{
no-summary | default-information-originate
}]
The parameters have the following meaning:
Area-ID specify a valid ID.
x.x.x.x
x = 0 ... 255
NSSA does not receive a summary
--
information-
Generating a standard route (LSA type
--
The area of the type NSSA is configured.
You change the type of the area with the no area command.
To Next Page
Loading...
Need help?
General