Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
533
Syntax
Call up the command with the following parameters:
ipv6 ospf area <IPv4-Address> [instance <instance-id>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
IPv4-Address
IPv4 address of the interface with which the
OSPFv3 protocol instance is connected.
specify the IP address in the
IPv4 address format.
x.x.x.x
instance
Keyword for the OSPFv3 protocol instance -
instance-id
ID of the OSPFv3 protocol instance specify the ID in the IPv4 ad-
dress format
x.x.x.x
Result
OSPFv3 on the interface is enabled.
Further notes
You configure the router ID with the router id command.
You disable OSPFv3 with the
no ipv6 ospf command.
You show the configuration of the OSPFv3 interface with the
show ipv6 ospf interface
command.
9.3.4.2
no ipv6 ospf
Description
With this command, you enable OSPFv3 on the interface.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● The router ID is configured.
● OSPFv3 routing is activated.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English