Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
189
Call up the command with the following parameters:
switchport acceptable-frame-type{all|tagged}
The parameters have the following meaning:
All frames are accepted.
O
n a ring port only the parameter
"all" is supported.
Default: all
Untagged frames are discarded. -
The setting is enabled.
You can reset the setting to the default with the no switchport acceptable-frame-type
command.
You can display the status of this function and other information with the
show vlan port
config
command.
no switchport acceptable-frame-type
Description
With this command, you reset the setting for the types of frames accepted by the interface to
the default value.
The default value is
all.
The interface accepts tagged and untagged frames.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call the command without parameters:
no switchport acceptable-frame-type
To Next Page
Loading...
Need help?
General