Siemens SCALANCE XR-500 Configuration Manual

Network protocols
7.4 DHCPv6 client (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
318 Configuration Manual, 11/2015, C79000-G8976-C252-10
Result
The DHCP config file request option is enabled.
Further notes
You enable the option with the ipv6 dhcp client reconfig-accept command.
7.4.2.8
ipv6 dhcp client request
Description
With this command you specify which configuration parameters will be requested, e.g. the
IPv6 address of the DNS server.
Requirement
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 dhcp client request {dns-server-address | domain-name | sntp-server-address |
option <code (1-100)>}
The parameters have the following meaning:
Parameter
Description
Range of values / note
dns-server-
address
IPv6 address of the DNS server -
domain-name
Domain name
-
sntp-server-
address
IPv6 address of the SNTP server -
option
Keyword for the option code
-
code
Number of the DHCPV6 option Enter the required number.
1 ... 200
Result
The setting is configured.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English